Alesis DM5Pro Kit Specifications download pdf (Page 65)

Programming Effects

DM PRO REFERENCE MANUAL 6 5

P8 The Reverb LOW DECAY Parameter

This Parameter subtracts low frequencies from the Reverb Decay (Page 6) so that

they fade out more quickly than the higher frequencies. This Parameter can make the

Reverb Effect sound brighter if set to a Value higher than the High Decay Parameter.

Higher Values will cause the low frequencies to fade faster. Lower Values will cause

the low frequencies to fade more slowly and affect the overall Reverb Decay less.

To adjust the Reverb Low Decay Value, move the cursor beneath the Value and then

turn the Value encoder to set the desired amount:

REVERB(Large)

Low Decay: -2 0

P9 The Reverb HIGH DECAY Parameter

This Parameter subtracts high frequencies from the Reverb Decay (Page 6) so that

they fade out more quickly than the lower frequencies. This Parameter can make the

Reverb Effect sound darker if set to a Value higher than the Low Decay Parameter.

Higher Values will cause the high frequencies to fade faster. Lower Values will cause

the high frequencies to fade more slowly and affect the overall Reverb Decay less.

To adjust the Reverb High Decay Value, move the cursor beneath the Value and then

turn the Value encoder to set the desired amount:

REVERB(Large)

High Decay: -4 0

Tip: Generally high frequencies fade faster than low frequencies. To make your

Reverb Effect sound as authentic as possible, set your High Decay to a higher

value than the Low Decay, generally by as much as a factor of 2.

P10 The Reverb DENSITY Parameter

This Parameter affects the actual timbre of the Reverb Effect. Higher Values will

increase the number of short echoes that compose the Reverb Effect, while lower

Values will decrease those echoes. The result is perceived as “thicker” reverb. High

densities are usually desirable on drum sounds, whereas lower densities are usually

desirable on vocal and guitar sounds. Generally, the lower the density, the more

transparent the Reverb Effect becomes.

To set the Reverb Density Value, move the cursor beneath the Value and then turn

the Value encoder to adjust the density of the Reverb Effect:

REVERB(Plate1)

P10

Density: 8 0

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 174 175

No comments

Alesis DM5Pro Kit Specifications Page 65