Alesis 24 Specifications download pdf (Page 80)

Description of Controls

STUDIO 24 REFERENCE MANUAL 7 9

AUXILIARY SEND SECTION

AUX 3 AND AUX 4 SENDS

These blue knobs are both mono post-fader sends typically used for effect sends

whose source is always the Channel FADER. The upper AUX 3 knob controls how

much signal will be sent to AUX SEND 3. The AUX 4 knob controls how much signal

will be sent to AUX SEND 4.

The unity-gain position of the AUX SENDS is the “2 o’clock position shown by the

heavy dot. 10dB of gain is available at full rotation.

MONITOR 1/2 LEVEL AND PAN (CHANNELS 1 - 8)

MONITOR 1/2 is a pre-fader, pre-mute stereo send typically used for control room

monitors and headphone feeds, or the stage monitors when the Studio 24 is used in a

live PA application.

Signal source: The MON 1/2 input comes from either the LINE IN/MIC IN jacks, or

the TAPE IN jack, as determined by the CHAN/MON REVERSE switch (see page

75).

Level: The purple LEVEL knobs control how much signal will be sent to the

MONITOR 1/2 MASTER. The LEVEL knob’s unity-gain position is at full rotation.

Pan: The left/right balance of the MON 1/2 mix is set by the black PAN control

directly above this knob. By turning the PAN fully left, the signal is routed only to

MON 1. When turned fully right, the signal is routed only to MON 2.

Tip: Note that, in most cases, this Pan control affects what you hear in the Control

Room or headphones, but NOT what’s going to tape.

MONITOR 1/2 LEVEL AND BAL

(STEREO CHANNELS 9 - 16)

As with Channels 1 - 8, MON 1/2 in the Stereo Channels are pre-fader, pre-mute

stereo sends that are usually used for control room monitors/headphone feeds, or

the stage monitors. Since there are no tape returns to the stereo Channels, there is no

CHAN/MON REVERSE switch, and inputs to these Channels are always routed pre-

fader to the Monitor.

Signal source: Stereo signals present in both inputs on the Channel are always

routed to MON 1/2 (Left to MON 1 and Right to MON 2). An instrument plugged

into the Left input only is routed as a mono signal to both MON 1 and MON 2. An

instrument plugged into the Right input only will be routed to MON 2 only.

Level: The purple LEVEL knobs control how much signal will be sent to the

MONITOR 1/2 MASTER.

Balance: Similar to the PAN control in Channels 1 - 8 that sets the left/right balance

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 104 105

No comments

Alesis 24 Specifications Page 80