Alesis 03D User Manual download pdf (Page 50)

40 Chapter 4—Input Channels

03D—Owner’s Manual

Channel Delay

The Delay function can be used to compensate for microphone placement, or simply

as a delay effect. Three types of delay are available: Delay, Slap, and Echo. Delay can be

applied to input channels 1 to 24 and the stereo input channel.

When channels are conﬁgured as a stereo pair using the Pair function (Stereo Pairs on

page 114), the channel delays of the two channels work together, and parameter adjust-

ments can be made with either channel selected. You cannot set different parameters for

the odd and even channels.

1. Use the [DELAY/∅] button to locate the CH Delay page shown below.

2. Use the [SEL] and [MIXING LAYER] buttons to select a channel. See Mix-

ing Layer on page 31 for more information.

3. Use the cursor buttons to select the delay parameters and the [ENTER]

button and PARAMETER wheel to set them.

If you are using a mouse, simply click the switches and drag the rotary controls.

ON/OFF—This switch is used to turn on and off the delay. When the cursor is located

within the PARAMETER window, the [ENTER] button can be used to turn on and off

the delay without having to select the ON/OFF switch.

TYPE—These switches are used to select the type of delay: DELAY, SLAP, or ECHO.

The echo parameters are reset when the type of delay is changed.

PARAMETER—The controls in this window are delay parameter controls. The num-

ber of controls available depends on type of delay selected.

When the type of delay is changed from Delay to either Slap or Echo, the parameters

are set as follows: Delay = 172 ms, Mix = 50%, Feedback = 18%. When the type is

changed from Slap or Echo to Delay, the parameters are set as follows: Delay = 0 ms,

Mix = 0%, Feedback = 0%.

Parameter Type Range Description

DELAY

SLAP

ECHO

9,600 samples

Delay can be speciﬁed in either seconds or sam-

ples. The actual delay in seconds depends on the

sampling rate. The maximum delay is 217.7 milli-

seconds at a sampling rate of 44.1 kHz, and 200.0

milliseconds at a sampling rate of 48 kHz.

MIX LEVEL

SLAP

ECHO

–100 to +100

Determines the level of delayed signal. 0 is no

delay. +50 is a 50:100 mix of delayed and dry sig-

nals. +100 is a 100:100 mix. Negative values are

the same except the delayed signal is inverted.

FB. GAIN

ECHO –99 to +99

Determines how much of the delayed signal is fed

back into the delay. 0 is no feedback. +99 is maxi-

mum feedback. Negative values are the same

except the feedback signal is inverted.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 301 302

Comments to this Manuals

No comments

Alesis 03D User Manual Page 50

Comments to this Manuals

Related products and manuals for Musical Instruments Alesis 03D