Alesis iMultiMix 16 USB Specifications download pdf (Page 17)

A Tour of the IMultiMix16 USB

8) AUX SENDS

And this is the 1/4” jack where you connect the line that’s going

into the input of an external effects processor. The aux sends give

you 10dB of gain that can be controlled in the AUX section of

each channel input.

9) ALT 3/4 OUT

These jacks are the outputs for the iMultiMix USB’s extra stereo

bus. This signal includes channels whose MUTE / ALT 3/4 switch

is activated.

10) 2-TRACK

The 2-TRACK IN and OUT jacks are standard RCA jacks. You’ll

use the OUTs for mixing to a tape deck or other recorder. With

the INs you can bring in a signal, which can be monitored and

even added to the main mix via the 2TK TO MIX switch in the

master section of the mixer.

11) MAIN MIX OUT

These 1/4” jacks are where the signal on the main mix bus leaves

the mixer. From there you can send it to a recorder or a PA system.

The level of this signal is controlled by the MAIN MIX fader.

12) CTRL RM OUT

You can use these 1/4" jacks to send the control room signal to

the input of the amplifier driving your monitors or headphones.

This output can carry several different signals, depending on which

source you have selected in the master section of the mixer.

Channel Strips

The eight channel strips are virtually identical to each other, with

the only difference being that channels 1 – 8 are mono and

channels 9 – 16 are stereo. Each channel strip contains the

following components.

1) Fader

The fader controls how much of the signal from the mic or line

inputs is sent to the channel. To adjust the level, simply slide the

fader up and down to the desired level. In the lowest position,

levels are cut completely, and in the uppermost position you get an

additional 10dB of gain. When the fader is at 0, it is at unity gain,

where the level of the output equals the level of the input.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

No comments

Alesis iMultiMix 16 USB Specifications Page 17